故障代码

仪表板通讯失败/Instrument panel communication failed : 检查仪表板与控制器连接线路/Check the circuit between the dashboard
and the controller.

电机A电流传感器异常/Motor A current sensor is abnormal : 检查控制器或电机A相线（黄线）部分线路/Check the line of the phase line
(yellow line) of the controller or motor A.

电机B电流传感器异常/Motor B current sensor is abnormal : 检查控制器或电机B相线（绿、棕线）部分线路/Check the controller or motor
B phase line (green, brown line) part of the line.

电机C电流传感器异常/Motor C current sensor is abnormal : 检查控制器或电机C相线（蓝线）部分线路/Check the controller or motor C
phase line (blue line) part of the line.

油门霍尔异常/Throttle Hall exception : 检查油门器是否复零位，油门线及油门器是否正常/Check if the throttle is zero, the throttle
line and the throttle are normal.

刹车霍尔异常/Brake Hall anomaly : 检查刹车把是否复零位，刹车线及刹车把是否正常/Check whether the brake will be reset to zero position,
and the brake line and the brake will be normal.

电机霍尔异常1/Motor Hall anomaly 1 : 检查电机霍尔接线（黄）是否正常/Check that the motor Hall wiring (yellow) is normal.

电机霍尔异常2/Motor Hall anomaly 2 : 检查电机霍尔接线（绿、棕）是否正常/Check whether the motor hall wiring (green, brown)
is normal.

电机霍尔异常3/Motor Hall anomaly 3 : 检查电机霍尔接线（蓝）是否正常/Check that the motor Hall wiring (blue) is normal.

BMS通讯异常/BMS communication anomaly : BMS通讯异常（非带通讯电池忽略）/BMS communication exception (non-communication
battery is ignored)

BMS密码错误/BMS password error : BMS密码错误（非带通讯电池忽略）/BMS password error (non-communication battery ignored)

BMS编号异常/BMS number exception : BMS编号异常（非带通讯电池忽略）/BMS number exception (ignored without communication
battery)

上桥MOS管故障/Upper bridge MOS tube fault : MOS管故障，重启后还报这个错误需要更换控制器/The MOS tube failed, and the error was
reported after restarting that the controller needed to be replaced.

下桥MOS管故障/Lower bridge MOS pipe failure : MOS管故障，重启后还报这个错误需要更换控制器/The MOS tube failed, and the error
was reported after restarting that the controller needed to be replaced.

电池温度异常/Battery temperature anomaly : 电池温度过高，检查电池温度，静放一段时间再开机/Battery temperature is too high, check
the battery temperature, static release for a period of time.

母线高压/Bus high voltage : 主线路电压过高/The main line voltage is too high.

系统过载/System overload : 超出系统负载/Exceed system load.

MOS相线短路/MOS phase line short circuit : 检查相线接线是否有短路/Check the phase line wiring for a short circuit.

控制器高温报警/Controller high temperature alarm : 控制器温度过高，静放车子冷却后再重启/The temperature of the controller is
too high, and the vehicle is restarted after the vehicle is cooled.