滑板车故障代码及故障处理
Scooter fault code and fault handling
短路故障/short trouble : 检查是否接线或安装有短路/Check if a short circuit is wired or installed
仪表板通讯失败/Instrument panel communication failed : 检查仪表板与控制器连接线路/Check the circuit between the dashboard and the controller.
电机A电流传感器异常/Motor A current sensor is abnormal : 检查控制器或电机A相线(黄线)部分线路/Check the line of the phase line (yellow line) of the controller or motor A.
电机B电流传感器异常/Motor B current sensor is abnormal : 检查控制器或电机B相线(绿、棕线)部分线路/Check the controller or motor B phase line (green, brown line) part of the line.
电机C电流传感器异常/Motor C current sensor is abnormal : 检查控制器或电机C相线(蓝线)部分线路/Check the controller or motor C phase line (blue line) part of the line.
油门霍尔异常/Throttle Hall exception : 检查油门器是否复零位,油门线及油门器是否正常/Check if the throttle is zero, the throttle line and the throttle are normal.
刹车霍尔异常/Brake Hall anomaly : 检查刹车把是否复零位,刹车线及刹车把是否正常/Check whether the brake will be reset to zero position, and the brake line and the brake will be normal.
电机霍尔异常1/Motor Hall anomaly 1 : 检查电机霍尔接线(黄)是否正常/Check that the motor Hall wiring (yellow) is normal.
电机霍尔异常2/Motor Hall anomaly 2 : 检查电机霍尔接线(绿、棕)是否正常/Check whether the motor hall wiring (green, brown) is normal.
电机霍尔异常3/Motor Hall anomaly 3 : 检查电机霍尔接线(蓝)是否正常/Check that the motor Hall wiring (blue) is normal.
BMS通讯异常/BMS communication anomaly : BMS通讯异常(非带通讯电池忽略)/BMS communication exception (non-communication battery is ignored)
BMS密码错误/BMS password error : BMS密码错误(非带通讯电池忽略)/BMS password error (non-communication battery ignored)
BMS编号异常/BMS number exception : BMS编号异常(非带通讯电池忽略)/BMS number exception (ignored without communication battery)
上桥MOS管故障/Upper bridge MOS tube fault : MOS管故障,重启后还报这个错误需要更换控制器/The MOS tube failed, and the error was reported after restarting that the controller needed to be replaced.
下桥MOS管故障/Lower bridge MOS pipe failure : MOS管故障,重启后还报这个错误需要更换控制器/The MOS tube failed, and the error was reported after restarting that the controller needed to be replaced.
电池温度异常/Battery temperature anomaly : 电池温度过高,检查电池温度,静放一段时间再开机/Battery temperature is too high, check the battery temperature, static release for a period of time.
母线高压/Bus high voltage : 主线路电压过高/The main line voltage is too high.
系统过载/System overload : 超出系统负载/Exceed system load.
MOS相线短路/MOS phase line short circuit : 检查相线接线是否有短路/Check the phase line wiring for a short circuit.
控制器高温报警/Controller high temperature alarm : 控制器温度过高,静放车子冷却后再重启/The temperature of the controller is too high, and the vehicle is restarted after the vehicle is cooled.